Table of Contents
Advertisement
6.8.10 CALIBRATION MENU Screen
All power sources are shipped with a Certificate of Compliance to NIST traceable standards
("CoC") from the factory. Output and Measurements are calibrated to an external reference
DMM at the same time. A suitable current shunt or current transformer and a load will be
required to perform calibration.
The following soft keys are available from the CALIBRATION MENU:
SOFT KEY
Calibrate (SK1)
Reset (SK2)
-
-
Back (SK5)
For details on calibration requirements and procedures, refer to the Calibration section
towards the end of this manual. (Section 11, "Calibration").
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Figure 6-37: CALIBRATION MENU Screen
Description
Enters calibration state
Resets all calibration coefficients' previous values.
Returns to previous screen
Table 6-37: Available CALIBRATION MENU screen soft keys
AFX SERIES® OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 182 of 485
- Quick Links:
- Block Diagram
Hide quick links:
Advertisement
Table of Contents
