Pacific Power Source AFX Series Operation Manual page 352

Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
SYSTem:COMMunicate:LAN:MACaddress?
This query returns the MAC address of the connected power source.
The Media Access Control address or MAC address is also referred to
as physical address as it is fix and unique to any device on the
network.
The MAC address for the power source is also printed on the rear
panel near the LAN interface connector. It consists of 8 sets of
hexadecimal 16 bit unsigned integer values.
<cr>
SYST:COMM:LAN:MAC?
3A.3F.00.4C.DE.AA.39.8F
SYSTem:COMMunicate:LAN:VISA?
Queries the VISA resource name / address string
<cr>
TCPIP::AFX-1003::INSTR
SYSTem:COMMunicate:LAN:APPly
Applies all changes send using the COMM:LAN commands.
None
n/a
SYST:COMM:LAN:APP
SYSTem:COMMunicate:LAN:MASK
This command sets the IP mark value for the power source LAN
interface. It is normally obtained through DCHP. If a static IP must be
used, the mask has to set as well.
ddd.ddd.ddd.ddd (four octets ranging in value from 0 to 255
representing one 16 bit unsigned integer value each.
<cr>
SYST:COMM:LAN:MASK 255.255.254.0
SYSTem:COMMunicate:LAN:MASK?
<cr>
SYST:COMM:LAN:MASK?
255.255.254.0
SYSTem:COMMunicate:LAN:DNSaddress
Sets the IP address for the DNS server
ddd.ddd.ddd.ddd (four octets ranging in value from 0 to 255
representing one 16 bit unsigned integer value each.
<cr>
SYST:COMM:LAN:DNS 132.18.21.208
SYSTem:COMMunicate:LAN:DNSaddress?
<cr>
SYST:COMM:LAN:DNS?
132.18.21.208
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 352 of 485