Pacific Power Source AFX Series Operation Manual page 328

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]PULSe:WAVEFORM# <nr1 >
This command sets the selected waveform using the wavefrom
number.
Waveform number
<nr1>, <cr>
PULS:WAVEFORM 1
[SOURce:]PULSe:WAVEFORM#?
<nr1>
PULS:WAVEFORM#?
1.0000
[SOURce:]PULSe:WAVEFORM#:MINimum?
This command returns the minimum permissible set value for the
PULSE waveform.
<nr1>
PULS:WAVEFORM#:MIN?
1
[SOURce:]PULSe:WAVEFORM#:MAXimum?
This command returns the maximum permissible set value for the
PULSE waveform.
<nr1>
PULS:WAVEFORM#:MAX?
200
[SOURce:]PULSe:WAVEFORM:DEFault?
This command returns the default set value for the PULSE waveform.
<nr1>
PULS:WAVEFORM:DEF?
1
[SOURce:]PULSe:PHASe# < nr2 >, <cr>
This command sets the initial PULSE phase angle for selected phase #
number. Only phase 2 (B) and 3 (C) are allowed.
Phase No., < NORmal | SATurate >
Default is NORmal if optional second parameter is omitted.
<nr1>, <cr>
PULS:PHAS1 245.0
[SOURce:]PULSe:PHASe#?
<nr1>, <cr>
PULS:PHAS1?
245.0000
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 328 of 485