Pacific Power Source AFX Series Operation Manual page 442

Grouping
Trigger Input:
STATUS
IMMEDIATE
AUTORUN
––Strobe Output:
TRANSIENT
OUTPUT STATE
SOURCE
External Sync:
STATUS
EXTERNAL SYNC
SYNC SOURCE
PHASE SHIFT
SPEED
RANGE
EXTERNAL SYNC
Remote Controls:
DISABLED
REMOTE INHIBIT
REMOTE ENABLE

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[ ON | OFF ] Enabled or disabled
[ ON | OFF ] Ignore phase update
setting if ON
[ ON | OFF ] No RUN command
required if ON
ON = Strobe output on transient
start
ON = Strobe output on relay close
ON = Strobe output on any program
parameter change
Display SYNC Status
[ ON | OFF ]
Select Sync source
Available sources are:
- External sync input on I/O
connector
- LINE (AC input to power source)
Offset Phase A angle
1.00 ~ 10.00
0.10 ~ 500 Hz
[ ON | OFF ]
No remote output control
Contact closure needed to close
output relay
Contact closure or front panel can
control output relay
AFX SERIES® OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Controls
Page 442 of 485