Pacific Power Source AFX Series Operation Manual page 171

6.8.5.3 LAN (ETHERNET) INTERFACE SETUP Screen
The LAN INTERFACE SETUP screen allows configuring the Ethernet interface for use with
your local area network (LAN) and is accessed from the INTERFACE SETUP screen.
Do NOT connect the RJ45 LAN (Ethernet) connector of the power source to a PoE
(Power over Ethernet) port as the DC voltage will damage the LAN interface.
This screen is used to configure the Ethernet interface for your local area network.
Note: You may need to consult your network administrator to set up this interface
correctly.
The following parameters can be set on this screen:
Automatic IP Configuration
IP
Mask
Gateway
DNS
Port

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
WARNING
Figure 6-28: ETHERNET INTERFACE SETUP Screen
Select this mode if your network has a domain name server
running. An IP address will be assigned by the DNS each
time the power source is turned on.
IP address setting. This address must be unique to your
network segment. Consult your network administrator if
you are not sure about this setting.
IP mask setting. This mask must be correct for your
network. Consult your network administrator if you are not
sure about this setting.
Gateway address setting. Consult your network
administrator if you are not sure about this setting.
Domain Name Server address setting. Consult your network
administrator if you are not sure about this setting.
Port socket address. For message based instruments like
this power source, this setting is typically 5025.
AFX SERIES® OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 171 of 485