Communication Serial Port Commands - Pacific Power Source AFX Series Operation Manual

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
8.9.8

Communication Serial Port Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
SYSTem:COMMunicate:LAN:PORT:TELNET
Sets the port address for TELNET protocol
1024–49151, default = 5024
<nr1>
SYST:COMM:LAN:PORT:TELNET 5024
SYSTem:COMMunicate:LAN:PORT:TELNET?
<nr1>
SYST:COMM:LAN:PORT:TELNET?
5024
SYSTem:COMMunicate:SERial[:ENABle]
This command is used to turn the RS232 serial interface on or off. To
use this interface for remote control of the power source, it must be
set to ON.
< 0 | OFF | 1 | ON >
<b>
SYST:COMM:SER ON
SYSTem:COMMunicate:SERial[:ENABle]?
<b>
SYST:COMM:SER?
1
SYSTem:COMMunicate:SERial:STATus?
This command returns all serial port settings
Baud rate, status,data bits, stop bits, parity, flow control
SYST:COMM:SER:STAT?
921600,0,8,1,0,0
SYSTem:COMMunicate:SERial:BAUD
This command sets the baud rate for the serial port.
< 1200 | 1800 | 2400 | 4800 | 9600 | 14400 | 19200 | 38400 | 57600 |
62500 | 115200 |230400 | 460800 |500000 | 576000 | 921600 >
<nr1>
SYST:COMM:SER:BAUD 115200
SYSTem:COMMunicate:SERial:BAUD?
<cr1>
SYST:COMM:SER:BAUD?
115200
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 354 of 485