System Settings Screen - Pacific Power Source AFX Series Operation Manual

6.8.8

SYSTEM SETTINGS Screen

This screen allows system level settings such date and time to be changed. It also access to
the UPC Compatibility mode setting.
The following parameters can be set from this screen:
Date
Time
Use Network Time Protocol
Time zone UTC offset
The soft keys on the SYSTEM SETTINGS screen provide access to additional functionality as
listed in the table below.
SOFT KEY
Apply All (SK1)
Cancel All (SK2)
Sanitize
Reboot
Back (SK5)

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Figure 6-35: SYSTEM SETTINGS Screen
Sets the date for the real-time clock.
Sets the time for the real-time clock.
When set, the time and date will be adjusted based on the
NTP protocol. This requires the unit to be connected to a
local area network.
This parameter sets the number of time zone from UTC
where the unit is located to reflect local time. Coordinated
Universal Time (UTC) is the primary time standard by which
the world regulates clocks and time. It does not observe
daylight saving time.
Description
Applies all changes made to this screen.
Cancels any changes made and returns to previous screen
Erases all user settings from the unit and returns it to its factory
default state.
Reboot front panel controller without cycling AC input power.
Returns to the previous screen.
Table 6-36: Available SYSTEM SETTINGS screen soft keys
AFX SERIES® OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 180 of 485