Gpib Device Interface (Option G); Table 5-7: Gpib Interface Connector Pin Assignments - Pacific Power Source AFX Series Operation Manual

5.18.6 GPIB Device Interface (Option G)

The GPIB interface uses the IEEE488.1 standard 24-pin D-Shell Amphenol micro ribbon connector.
Using a standard GPIB cable, the cable will break out to the left of the unit when facing the rear. This
will typically obstruct USB and LAN interface connector access. Reverse GPIB cables are available but
using these will obstruct the Auxiliary I/O connector.
The GPIB pin assignments are per the IEEE488.1 standard and listed in the table below.
PIN
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Pin 9
Pin 10
Pin 11
Pin 12
Pin 13
Pin 14
Pin 15
Pin 16
Pin 17
Pin 18
Pin 19
Pin 20
Pin 21
Pin 22
Pin 23
Pin 24

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Signal
DIO1 Data input/output bit.
DIO2 Data input/output bit.
DIO3 Data input/output bit.
DIO4 Data input/output bit.
EOI End-or-identify.
DAV Data valid.
NRFD Not ready for data.
NDAC Not data accepted.
IFC Interface clear.
SRQ Service request.
ATN Attention.
SHIELD
DIO5 Data input/output bit.
DIO6 Data input/output bit.
DIO7 Data input/output bit.
DIO8 Data input/output bit.
REN Remote enable.
GND (wire twisted with DAV)
GND (wire twisted with NRFD)
GND (wire twisted with NDAC)
GND (wire twisted with IFC)
GND (wire twisted with SRQ)
GND (wire twisted with ATN)
Logic ground

Table 5-7: GPIB Interface Connector Pin Assignments

AFX SERIES® OPERATION MANUAL
SECTION 5: UNPACKING AND INSTALLATION
Description
Page 90 of 485