Pacific Power Source AFX Series Operation Manual page 299

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Syntax
Description
Parameters
Parameter Format
Query Example
Query Syntax
Description
Parameters
Parameter Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]IMPEDance:L
This command sets the L value for the output impedance. Available
programming range is -0.00000000
<L>
<nr2>
IMPED:L 0.00002
[SOURce:]IMPEDance:L?
<nr2>
IMPED:L?
0.00002
[SOURce:]IMPEDance:L[:LIMit]:MAXimum?
This command return the maximum allowable setting value for the L
component of the output impedance.
None
N/A
IMPED:L:MAX?
0.00005000
[SOURce:]IMPEDance:L[:LIMit]:MINimum?
This command return the minimum allowable setting value for the L
component of the output impedance.
None
N/A
IMPED:L:MIN?
0.00000000
[SOURce:]IMPEDance:MODE
This command sets the programmable impedance mode to either
Real-Time mode (0) or RMS Mode (1). See page 161 for a description
of both impedance modes.
0 Real mode.
1 RMS mode.
Note: To change programmable impedance modes, the output of
the power source must be turned OFF first. Trying to change
modes while the output is ON will result in an error message.
< 0 | 1 >
<b>
IMPED:MODE 1
[SOURce:]IMPEDance:MODE?
<b>
IMPED:MODE?
1
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
~
0.00005000
(Henry).
Page 299 of 485