Pacific Power Source AFX Series Operation Manual page 281

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]WAVEFORM:DEFine
This command sends a string of 1024 data points that constitute a
single period of an arbitrary waveform. The data is sent as a comma
separated list of <nr2> values. The waveform name to which to apply
the new data values is the first parameter in the list and can be from
1 through 16.
Note: Data values are scaled based on an RMS value of 1 so for a sine
wave, the max data value is 1.414 and the min data value is -1.414
1024 data values separated by commas
<nr1>,<nr2>, <nr2>,.......,<nr2>
WAVEFORM:DEF 16,0.0000,0.0068,0.0135,0.0203,...,-0.0203,-
0.0135,-0.0068
[SOURce:]WAVEFORM:DEFine? <nr1>
<nr2>, <nr2>,.......,<nr2>
SOURce:WAVEFORM:DEF? 16
0.0000,0.0068,0.0135,0.0203, .... ,-0.0203,-0.0135,-0.0068
[SOURce:]WAVEFORM:DELete <nr1>
This command deletes a user defined waveform from any location
higher than 1.
Waveform number
<nr1>
WAVEFORM:DEL 16
[SOURce:]WAVEFORM:EXIST? <nr1>
This command returns a 1 if the waveform location referenced
contains waveform data or a 0 is the waveform location is empty (No
waveform exists).
<nr1>
WAVEFORM:EXIST? 34
0
[SOURce:]WAVEFORM#:LOAD
This command loads the currently selected waveform to the actual
output register of the controller causing it output the waveform on
the selected phase #.
1, 2, 3
<nr1>
WAVEFORM1:LOAD
[SOURce:]WAVEFORM#:LOAD? <nr1>
<nr1>, <cr>
SOURce:WAVEFORM1:LOAD? 1
1, Sine
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 281 of 485