Pacific Power Source AFX Series Operation Manual page 244

8.6.1.2 Transient Segment Output Parameter List Table
The following table details the available parameters for the transient segment program
definitions.
Parameters
SEGment,<n>
FSEG,<n>
VSEG,<n>
VSEG1,<n>
VSEG2,<n>
VSEG3,<n>
WFSEG,<n>
WFSEG1,<n>
WFSEG2,<n>
WFSEG3,<n>
TSEG,<n>
LAST

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
SECTION 8:
Query: The NSEGS parameter of a :PROG:DEF? query returns total
number of Transient segments defined in the selected program
Description
Transient segment n of the selected program to be edited. Also the
starting segment when querying multiple segments (see NSEGS)
n = <1> to <100>
sets objective Frequency of selected segment
n = <:SOUR:FREQ:LIM:MIN> to <:SOUR:FREQ:LIM:MAX> Hz
sets objective voltage ФA, ФB, ФC of selected segment
n = <0> to <300 x XFMRRATIO> Volts
sets objective voltage ФA of selected segment
n = <0> to <300 x XFMRRATIO> Volts
sets objective voltage ФB of selected segment
n = <0> to <300 x XFMRRATIO> Volts
sets objective voltage ФC of selected segment
n = <0> to <300 x XFMRRATIO> Volts
sets Waveform ФA, ФB, ФC of selected segment
n = <1> to <16>
sets Waveform ФA of selected segment
n = <1> to <16>
sets Waveform ФB of selected segment
n = <1> to <16>
sets Waveform ФC of selected segment
n = <1> to <16>
sets execution time (to reach objective Voltage and Frequency) of
selected segment
n = <0> or <0.0002> to <300> seconds. Setting n to a negative value
such as -5 selects cycle-based transient operation, i.e., each
segment time is equal to the period of 5 cycles (1 cycle = 1/FREQ
secs)
sets selected segment to be the last segment of selected transient
AFX SERIES® OPERATION MANUAL
Remote Control Programming
Page 244 of 485