Cabinet Systems Installation; Standard Cabinet Sizes; Tools Required - Pacific Power Source AFX Series Operation Manual

5.15 Cabinet Systems Installation

AFX Series® power sources above 15kVA output are available pre-installed and pre-wired in
a 19-inch cabinet. These cabinet systems include all internal AC input and AC or DC output
wiring. Several options can be added to these AFX cabinet systems as well.
Note AC input, AC Load and sense wiring are NOT included with the power source Cabinet
and must be supplied by the end-user. Only internal cabinet wiring and terminal
blocks are included.

5.15.1 Standard Cabinet Sizes

All standard AFX cabinet systems feature the same depth and width but height may vary by
power level to accommodate more or less AFX units.
The following two sizes are currently offered.
15U
•
• 28U
Note that alternative cabinet sizes and power levels may be supported for special
requirements so this information applies to catalog models only.
Refer to cabinet dimension drawings shown below for the two available cabinet dimensions.

5.15.2 Tools Required

Installing AC Input and AC/DC Output cable connections to the terminal blocks furnished
with AFX cabinet systems requires the use of a Phillips screwdriver to remove the rear panel
screen and some Allen (Hex) wrenches for the terminal blocks.
#2 x 6 Phillips Screw driver. Not included in AFX Cabinet ship kit.
Allen Wrenches, 3/16" and 5/16" Size (SAE, non-metric). Included in AFX Cabinet ship kit.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
For power levels of 18kVA, 24kVA, 30kVA or 45kVA
For power levels of 60kVA and higher
AFX SERIES® OPERATION MANUAL
SECTION 5: UNPACKING AND INSTALLATION
Page 73 of 485