Pacific Power Source AFX Series Operation Manual page 264

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]RANGe
Selects high or low voltage range. Although the AFX Series® has only
a single voltage range, this commands allows simulation of a dual
range AC voltage source which is more familiar to some users.
Despite this virual low range capability, no actual physical range
change takes places so the output is never interrupted.
Note: When switching from HIGH to LOW range, the output voltage
may be reduced to the highest available voltage on the low range.
< 0 | LOW | 1 | HIGH >
<b>
RANG HIGH
[SOURce:]RANGe?
<b>
RANG?
1
[SOURce:]RAMP#
Sets voltage slew rate for selected phase number or for all phases if
no phase number is specified.
Slew rate
<nr2>
SOUR:RAMP3 10.5
[SOURce:]RAMP#?
Returns voltage slew rate setting for specified phase (1, 2 or 3) or for
phase 1 (A) if no phase number is specified.
SOUR:RAMP3?
10.5000
[SOURce:]UPDATEPHase
Set the phase angle at which programmed voltage changes on phase
A will take place. This applies to output on and off phase angle
placement as well. Available range is from 0° through 360.0°
inclusive. Values higher than 360.0° will be truncated to 360.0000°
automatically.
< 0.0000 - 360.0000 >
<nr2>
UPDATEPH 90.00
[SOURce:]UPDATEPHase?
<nr2>
SOURce:UPDATEPH?
90.0000
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 264 of 485