External Voltage Sense Connector Rating And Isolation; Load Connection Without External Voltage Sense; Load Connection With External Voltage Sense - Pacific Power Source AFX Series Operation Manual

7.2.1

External Voltage Sense Connector Rating and Isolation

Maximum rated voltage:
Maximum Current Rating:
Connector Type:
Designated Use:
Isolation Rating:
Wire Stripping Length:
7.2.2

Load Connection without External Voltage Sense

AFX Series® power sources can be operated with internal voltage sense. For higher current
loads, the voltage at the load will drop due to the load cable impedance. Using the proper
wire gauge for the rated current of the AC source is required to minimize load cable
impedance.
7.2.3

Load Connection with External Voltage Sense.

The following points must be considered, when existing sense cables are connected directly
to the load or to the central load distribution point:
1. Minimize the distance between the AC power source and the load as much as
possible to keep load wire length to a minimum.
2. Directly connect A, B, C and N with
3. Twist each phase sense wire with a neutral sense wire to minimize cross talk. Three
neutral connection points are provided for this purpose.
4. Avoid overload of power wires

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
AFX SERIES® OPERATION MANUAL
Rear Panel, Connectors and Protection
SECTION 7:
400V rms AC, 425Vdc
1A
AFX L Version: Phoenix Contact P/N DFK-MSTBA
2,5 / 6-GF-5,08 – 1899029. Mating connector
provided in ship kit is P/N FKC 2,5 / 6-STF-5,08 -
1873249
AFX A Version: Phoenix Contact P/N SPT 5 / 6-H-
7,5-ZB - 1719231
AC or DC Load Connection
600V
10 mm
correct phasing to the load distribution point
Page 188 of 485