Unpacking T Option Chassis; Cabinet Installation - Pacific Power Source AFX Series Operation Manual

5.21.3 Unpacking T Option Chassis

THIS UNIT IS HEAVY. Two persons are required to lift or carry this unit. DO NOT attempt to lift
alone. DO NOT use the front panel rack handles alone to lift this unit. The unit must be supported
in front and back when carrying.
CET EQUIPEMENT EST LOURD. Deux personnes sont requises pour transporter ou soulever cet
équipement. NE PAS tenter de soulever ou déplacer seul. NE PAS utiliser les poignées en face
avant pour soulever l´appareil. L´équipement doit être pris en charge à l´avant et à l´arrière pour
le transport.
The AFX Transformer chassis weighs nearly 200 lbs so it is
highly recommended that lifting aids be used to remove the
unit from its packaging. To assist in removing the unit from
its package, two flip-down grab handles are located on each
side of the chassis towards the rear.
Note: These grab handles should be removed when
installing the transformer option in a 19" cabinet.
When using the chassis on a bench, they can be left
in place.

5.21.4 Cabinet Installation

When installing this option in a 19" rack, either
heavy-duty rack slides or heavy-duty L- brackets
MUST be used to support the weight of the unit.
Contact customer services for available slides
and L-brackets.
Refer to the cabinet shown to the right for
details.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
WARNING
AVERTISSEMENT
AFX SERIES® OPERATION MANUAL
SECTION 5: UNPACKING AND INSTALLATION
Page 100 of 485