Pacific Power Source AFX Series Operation Manual page 268

Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
VOLT:INIT? = ON
VOLT:INIT? = OFF
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]VOLTage[:AC]#:LIMIT:SATuration:MAXimum?
Returns maximum sine wave RMS voltage at which saturation of the
output inverter will occur.
See [SOURce:]VOLTage[:AC]#:LIMIT:SATuration:RANGe? for details.
<nr2>
VOLT:AC3:LIM:SAT:MAX?
301.154
[SOURce:]VOLTage[:AC]#:LIMIT:SATuration:MINimum?
Returns minimum sine wave RMS voltage at which saturation of the
output inverter will occur.
See [SOURce:]VOLTage[:AC]#:LIMIT:SATuration:RANGe? for details.
<nr2>
VOLT:AC3:LIM:SAT:MIN?
0.000
[SOURce:]VOLTage[:AC]:INITial
This command is equivalent to the "[SOURce:]INITial <n>" command
but applies only to the AC1, AC2 and AC3 parameters.
Set points of the unit at power on will be the last set after power off.
The set points affected by this command are:
- Voltage AC1
- Voltage AC2
- Voltage AC3
Set points of the unit at power on will have a default value of:
- Voltage AC1 = 0V
- Voltage AC2 = 0V
- Voltage AC3 = 0V
< 0 | OFF | 1 | ON >
<b>
VOLT:AC:INIT OFF
[SOURce:]VOLTage[:AC]:INITial?
<b>
VOLT:AC:INIT?
0
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 268 of 485