Pacific Power Source AFX Series Operation Manual page 282

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]WAVEFORM:RESTORE
This command restores the first 16 waveforms registers by replacing
waveform 1 to 16 with the factory defaults. See section 8.7.6.
Note: This command is useful if waveforms 2 through 15 were
overwritten with user-defined waveforms.
None
n/a
WAVEFORM:RESTORE
None
[SOURce:]WAVEFORM#:SELect
This command selects a waveform by alias (name) or number. When
using the WAVEFORM:x commands, the ALIAS|NUMBER is not
passed as it uses the selected one. This is to avoid passing the
waveform number to every command
<ALIAS|NUMBER, OPT: ALIAS|NUMBER , OPT: ALIAS|NUMBER >
The first parameter is required. Additional optional waveforms or
numbers may be added when operating the source in 2 or 3 phase
mode. The waveform selection sequence by phase is A, B, C.
<cr> or <nr1>
WAVEFORM:SEL SINE
WAVEFORM:SEL 1,2,3
WAVEFORM:SEL 5
[SOURce:]WAVEFORM#:SELect?
<cr> or <nr1>
WAVEFORM:SEL?
1,1,1 (FORM 3)
WAVEFORM:SEL?
1,1 (FORM 2)
WAVEFORM:SEL?
1 (FORM 1)
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 282 of 485