Pacific Power Source AFX Series Operation Manual page 308

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]STEP:VOLTage[:AC]:FINal# < nr2 >, <cr>
[SOURce:]STEP:VOLTage[:AC]:FINal#
Voltage phase A, OPT: Voltage phase B, OPT: Voltage phase C, OPT
This command sets the final STEP voltage for selected phase # or for
all phases if phase reference is omitted.
Voltage , < NORmal | SATurate >
Default is NORmal if optional second parameter is omitted.
<nr2>, <cr>
STEP:VOLT:FIN 180.00, SAT
[SOURce:]STEP:VOLTage[:AC]:FINal#?
<nr2> | <nr2>,<nr2>,<nr2>
STEP:VOLT:FIN?
180.000,180.000,180.000
[SOURce:]STEP:VOLTage[:AC]:FINal#:MINimum?
This command returns the minimum permissible set value for the
final STEP voltage for selected phase # or for all phases if phase
reference is omitted
<nr2>
STEP:VOLT:FIN1:MIN?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
[SOURce:]STEP:VOLTage[:AC]:FINal#:MAXimum?
This command returns the maximum permissible set value for the
final STEP voltage for selected phase # or for all phases if phase
reference is omitted
<nr2>
STEP:VOLT:FIN1:MAX?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
[SOURce:]STEP:VOLTage[:AC]:FINal#:DEFault?
This command returns the default set value for the final STEP voltage
for selected phase # or for all phases if phase reference is omitted
<nr2>
STEP:VOLT:FIN1:DEF?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 308 of 485