Pacific Power Source AFX Series Operation Manual page 471

Error Source Code
Front panel 333
Fault
Front panel 334
Fault
Front panel 335
Fault
Front panel 336
Fault
Front panel 337
Fault
Front panel 338
Fault
Front panel 339
Fault
Front panel 340
Fault
Front panel 341
Fault
Front panel 342
Fault
Front panel 343
Fault
Front panel 344
Fault
Front panel 345
Fault
Front panel 346
Fault
Front panel 347
Fault
Front panel 348
Fault

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Category Error Message
Error Node in non-operational
mode. Run unit discovery
to recover.
Error Power failure.
Error Remote inhibit was issued
from remote interface.
Error System about to reboot.
Error Missed node.
Error One or more inverters did
not get enabled.
Error One or more primaries
did not get enabled.
Error Firmware version
mismatch
Error Firmware version
mismatch. Front panel
version is older than
expected. Contact
technical support.
Error Mismatch between
hardware revisions of
units in parallel.
Error Power stage firmware
update failed.
Error Firmware update was
interrupted
Error GPIB hardware not found
in this unit.
Error GPIB hardware detected
Error IO hardware not found in
this unit.
Error IO hardware detected
AFX SERIES® OPERATION MANUAL
Service and Maintenance
SECTION 13:
Possible Cause
An inconsistency was
detected in the power
source's internal
communication network.
Setting conflict. Remote
inhibit conflicts with
Output state
Notification. Reboot
imminent. Normal after
completing front panel
firmware update
An inconsistency was
detected in the power
source's internal
communication network.
Failed to enable one or
more output power
stages
Failed to enable one or
more input power stages
Firmware Error. Power
stage firmware version is
older than expected
Firmware Error. Front
panel firmware version is
older than expected
Error during discovery.
Not all paralleled units
are of same hardware
revision
Send command:
SYSTem:FW:POWER:UPD
ATE:STAT? for more
information
Recovery is needed
Configuration Error. GPIB
Interface option not
found
Configuration Error. GPIB
Interface found but not
configured
Configuration Error. Aux
I/O hardware missing
Configuration Error. Aux
I/O hardware found but
not configured
Resolution
Turn unit off, check
parallel cable connections
if present and then turn
unit back on. If problem
recurs, contact customer
service.
Check AC input voltage. If
error persists, contact
customer service
Check Remote inhibit
mode setting and
connections
Wait for all firmware
updates to be completed
Try recycling power. If
error persists, contact
customer service
Try recycling power. If
error persists, contact
customer service
Try recycling power. If
error persists, contact
customer service
Check for correct
firmware image file and
version.
Check for correct
firmware image file and
version.
Contact customer service
Run unit discovery to
recover.
Check model type tag for
installed options
Check model type tag for
installed options
Check model type tag for
installed options
Check model type tag for
installed options
Page 471 of 485