Current Programming Commands - Pacific Power Source AFX Series Operation Manual

Query Format
Description
Returned Data Format
Query Example
8.7.4

Current Programming Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]FREQuency:SPAN?
This command is provided to support backward compatibility with
Pacific Power UPC controllers. Refer also to the
"SYSTem:COMPatible" command. For AFX Series®, this query always
returns 1200.0000
<nr2>
FREQ:SPAN?
1200.0000
[SOURce:]CURRent:LIMit#
This command sets the programmable current level for the selected
phase #. If # is omitted, sets all phases to current level specified. The
value set cannot exceed the maximum current capability of the
power source as returned by the "[SOURce:]CURRent:LIMit#:MAX?"
command.
If the load current exceeds the current limit set point, the source will
go into constant current mode to maintain the load current at the set
limit level.
0.00 – MAX
<nr2>
CURR:LIM 20.5
[SOURce:]CURRent:LIMit#?
<nr2>
CURR:LIM?
41.667,41.667,41.667
[SOURce:]CURRent:LIMit#:MAX?
This command returns the maximum available programmable current
limit setting. Note that the returned value is a function of the
"SYSTem:COMPatible" setting
UPC If UPC mode is enabled, this command always returns 2000.0000 to
emulate the UPC controllers
DISABLED With UPC mode disabled, this command returns the max. available
current output per phase. This value is a function of the AFX model
and the number of units that are connected in parallel.
<nr2>
CURR:LIM:MAX?
41.6667
[SOURce:]CURRent:LIMit#:DEFault?
This command returns the default current limit setting at power up
for the referenced phase.
<nr2>
CURR:LIM1:DEF?
41.67
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 274 of 485