Digital Output Control Signals - Pacific Power Source AFX Series Operation Manual

changes. A slower speed improves the stability of the waveform frequency, so it is
recommended to use the smallest possible speed values.
Command: SOURce:SYNChronize:SPeed
3 Range: Allows configuration of how much the synchronization engine is able to
deviate from the AFX programmed frequency. This helps to keep the waveform
frequency under control, even if the external source is not present all the time. The
synchronization engine is limited to frequencies of FSETPOINT +/- FRANGE.
Command: SOURce:SYNChronize:RANGe
7.3.8

Digital Output control signals

External Relay Control #1 - FORM
•
External Relay Control #2 - TRANSFORMER
•
Trigger Output / Function Strobe
•
Phase Sync Output
•
7.3.8.1 Function Strobe / Trigger Out
The external trigger output can be programmed to generate an output pulse on the
following events:
a. The start of a transient program (Transient Trigger)
b. Output Replay State Change
c. Any parameter change. Parameter changes that generate an output function strobe
pulse are:
i. Voltage on any phase
ii. Frequency
iii. Waveform on any phase
iv. Phase angle

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Rear Panel, Connectors and Protection
SECTION 7:
TRIGGER
OUT
AFX SERIES® OPERATION MANUAL
Page 198 of 485