Waveform Programming Commands - Pacific Power Source AFX Series Operation Manual

8.7.6

Waveform Programming Commands

Waveform Storage
The AFX Series® offers full arbitrary waveform programming capability in addition to the
standard waveforms that are provided. A total of 16 waveform registers are available. The
default content of these registers is shown in the table below. Also shown are the waveform
number names and the waveform description each waveform.
Name
1
2
3
4
5
6

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Description
SINE
CLIPPED THD 1%
CLIPPED THD 2%
CLIPPED THD 5%
CLIPPED THD 10%
SQUARE LF
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Image Notes
Standard sine wave. No
harmonic content. This is
also the default selected
waveform at power on
unless a power-on setup is
recalled.
Clipped sine with 1% total
harmonic voltage distortion
due to flat topping of
sinewave peaks.
Clipped sine with 2% total
harmonic voltage distortion
due to flat topping of
sinewave peaks.
Clipped sine with 5% total
harmonic voltage distortion
due to flat topping of
sinewave peaks.
Clipped sine with 10% total
harmonic voltage distortion
due to flat topping of
sinewave peaks.
Square wave. Consists of
fundamental and all odd
harmonics. The LF (low
frequency) version is
recommended for use below
100Hz.
Page 278 of 485