Pacific Power Source AFX Series Operation Manual page 266

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]VOLTage[:AC]#
Sets AC voltage for phase #. If # is omitted, sets all available phases to
value specified.
Range 0.0000 - 300.0000
<nr2>
VOLT:AC1 100.00
[SOURce:]VOLTage[:AC]#?
Returns voltage setting for specified phase. If phase is omitted,
returns voltage setting for phase A.
<nr2>
VOLT:AC1?
100.0000
[SOURce:]VOLTage[:AC]#:SLEW
Sets AC voltage slew rate for phase # in Volts per msec. If # is
omitted, sets phase A slew rate to value specified.
Range 0.01 – 300.0
<nr2> and <nr3>
VOLT:AC1:SLEW 300.00
[SOURce:]VOLTage[:AC]#:SLEW?
Returns voltage slew rate setting for specified phase. If phase is
omitted, returns voltage setting for phase A.
<nr2>
VOLT:AC1:SLEW?
300.0000
[SOURce:]VOLTage[:AC]:LIMit:MINimum
Sets low user limit for AC voltage programming. User limits must fall
within actual hardware limits of the power source. Also, MIN limit
must be less than MAX limit.
0.000 – 300.000
<nr2>
VOLT:LIM:MIN 20.0
[SOURce:]VOLTage[:AC]#:LIMit:MINimum?
<nr2>
VOLT:LIM:MIN?
20.0000
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 266 of 485