Pacific Power Source AFX Series Operation Manual page 475

Error Source Code
I/O Board 393
I/O Board 394
I/O Board 395
I/O Board 396
I/O Board 397
I/O Board 398
I/O Board 399
I/O Board 400
I/O Board 401
I/O Board 454
I/O Board 455
I/O Board 456
Front panel 500
Front panel 501
Front panel 502

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Category Error Message
Internal Global fault detected.
Error
Error Internal board fault.
Error Invalid node ID. Run unit
discovery to recover.
Error Incorrect DSP type
detected. Cycle-power to
re-try.
Error Invalid constants loaded
from EEPROM.
Error Controller is not in
operational node.
Error Transformer coupling
circuits hardware fault.
Error Transformer coupling
circuits not detected.
Error Remote inhibit was issued
from remote interface.
Error Controller is not in
operational node.
Error Missing controller node.
Error Cannot read fault
information.
Warning AC voltage setpoint was
automatically reduced to
0 Vrms.
Error Frequency is too high to
enable xfmr coupling.
Error Extended voltage range is
not allowed when
AFX SERIES® OPERATION MANUAL
Service and Maintenance
SECTION 13:
Possible Cause
Hardware Fault
An inconsistency was
detected in the power
source's internal
communication network.
Internal Communication
Error. AUX I/O processor
not responding
Configuration Error.
Coefficients found are
invalid.
An inconsistency was
detected in the power
source's internal
communication network.
An inconsistency was
detected in the power
source's internal
communication network.
An inconsistency was
detected in the power
source's internal
communication network.
An inconsistency was
detected in the power
source's internal
communication network.
Resolution
Try recycling power. If
error persists, contact
customer service
Turn unit off, check
parallel cable connections
if present and then turn
unit back on. If problem
recurs, contact customer
service.
Try recycling power. If
error persists, contact
customer service
SANITIZE unit to restore
factory defaults
Turn unit off, check
parallel cable connections
if present and then turn
unit back on. If problem
recurs, contact customer
service.
Turn unit off, check
parallel cable connections
if present and then turn
unit back on. If problem
recurs, contact customer
service.
Turn unit off, check
parallel cable connections
if present and then turn
unit back on. If problem
recurs, contact customer
service.
Turn unit off, check
parallel cable connections
if present and then turn
unit back on. If problem
recurs, contact customer
service.
Page 475 of 485