Ramp Time & Slew Rate - Pacific Power Source AFX Series Operation Manual

10.9.3 Ramp Time & Slew Rate
The Slew Rate screen has entries for all available programmable slew rate settings. This includes
Voltage AC, Voltage DC, Frequency and Phase Angle. Note that both are mutually exclusive as
they would conflict with each other. To use programmable slew rates, the RAMP TIME must be
disabled.
Slew Rates can be set for Voltage AC, Voltage DC and Frequency.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
AFX SERIES® OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Page 433 of 485