Honda Accord 2008 Manual page 2904

Hide thumbs Also See for Accord 2008:
Table of Contents

Advertisement

07/11/02 09:54:12 61TA0000_240_0181
24. Measure the resistance between the No. 10
terminal of the ODS unit harness 18P connector
and body ground. There should be an open circuit
or at least 1 M .
*10
Is the resistance as specif ied?
YES
NO
replace the ODS unit harness.
25. Measure the resistance between the No. 10
terminal and No. 15 terminal of the ODS unit
harness 18P connector. There should be an open
circuit or at least 1 M .
*11
Is the resistance as specif ied?
YES
(see page 24-232).
NO
ODS unit harness.
ODS UNIT HARNESS 18P CONNECTOR
Wire side of female terminals
Go to step 25.
Short to ground in the ODS unit harness;
ODS UNIT HARNESS 18P CONNECTOR
Wire side of female terminals
Faulty ODS unit; replace the ODS unit
Short in the ODS unit harness; replace the
DTC 83-26:
No Signal From the Front
Passenger's Weight Sensor (rear outer side)
(4-door)
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures (see page
24-23) and General Troubleshooting Information
(see page 24-35).
1. Clear the DTC memory (see page 24-36).
2. Read the DTC (see page 24-36).
Is DT C 83-26 indicated?
YES
Go to step 3.
NO
Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37).
3. From INSPECTION menu on the HDS, select SWS
DTC CHECK.
Is another DT C also indicated?
YES
• DTC 26-11: Short to power in front passenger's
weight sensor (rear outer side) power circuit;
replace the ODS unit harness.
• DTC 26-12: Short to ground in the front
passenger's weight sensor (rear outer side)
power circuit. Go to step 4.
• DTC 26-13: Short to power in the front passenger's
weight sensor (rear outer side) output circuit.
Go to step 11.
• DTC 26-14: Short to ground in the front
passenger's weight sensor (rear outer side)
output circuit. Go to step 19.
NO
Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37).
4. Turn the ignition switch to LOCK (0).
TA08AB4K791000R8326FAAT00
(cont'd)
24-181
24-181

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents