Honda Accord 2008 Manual page 2899

07/11/02 09:53:09 61TA0000_240_0176
SRS
DTC Troubleshooting (cont'd)
11. Turn the ignition switch to LOCK (0).
12. Swap the connections between the rear inner side
front passenger's weight sensor and the front inner
side sensor.
13. Read the DTC.
Is DT C 16-13 indicated?
YES
NO −
inner side); replace the front passenger's seat
frame including all four front passenger's weight
sensors (see page 24-230).
14. Turn the ignition switch to LOCK (0).
15. Disconnect the front passenger's weight sensor
(front inner side) connector (A) and front
passenger's weight sensor (rear inner side)
connector (B).
＊０５
24-176
− Go to step 14.
Faulty front passenger's weight sensor (rear
16. Disconnect the ODS unit harness 18P connector (A)
from the ODS unit.
17. Turn the ignition switch to ON (II).
18. Measure the voltage between the No. 9 terminal of
the ODS unit harness 18P connector and body
ground. There should be 1 V or less.
ODS UNIT HARNESS 18P CONNECTOR
B
A
Is the voltage as specif ied?
−
YES Faulty ODS unit; replace the ODS unit
(see page 24-232).
NO − Short to power in the ODS unit harness;
replace the ODS unit harness.
A
Wire side of female terminals
＊０６
＊０７