07/11/02 09:49:37 61TA0000_240_0137
10. Do the battery terminal reconnection procedure
(see page 22-89).
11. Turn the ignition switch to ON (II).
12. Measure the voltage between the No. 38 terminal
of SRS unit connector B (39P) and body ground,
and between the No. 39 terminal and body ground.
There should be less than 1.0 V.
*53
Is the voltage as specif ied?
YES
NO
−
replace the SRS floor wire harness.
13. Turn the ignition switch to LOCK (0).
14. Connect the SRS inflator simulator (jumper
connector) and the black lead (A) of simulator lead
L to the left engine compartment wire harness 4P
connector (B).
*04
070AZ-SNAA300
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
−
Go to step 13.
Short to power in the SRS floor wire harness;
B
A
15. Measure the resistance between the No. 38 and the
No. 39 terminals of SRS unit connector B (39P).
There should be less than 1
Is the resistance as specif ied?
−
YES
unit; replace the right side impact sensor (first)
(see page 24-226). If the problem is still present,
replace the SRS unit (see page 24-223).
NO
−
the SRS floor wire harness.
07SAZ-TB4011A
.
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
Faulty right side impact sensor (first) or SRS
Open in the SRS floor wire harness; replace
*54
24-137