Honda Accord 2008 Manual page 2787

07/11/02 09:45:54 61TA0000_240_0064
SRS
DTC Troubleshooting (cont'd)
10. Disconnect the dashboard wire harness 4P
connector (A) from the cable reel.
＊５２
07SAZ-TB4011A
11. Connect the SRS inflator simulator (2
connectors) and the simulator lead to the
dashboard wire harness.
12. Do the battery terminal reconnection procedure
(see page 22-89).
13. Clear the DTC memory.
14. Read the DTC.
Is DT C 11-1x or 11-4x indicated?
YES
NO −
(see page 24-220).
24-64
A
−
Go to step 15.
Open in the cable reel; replace the cable reel
15. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
16. Disconnect SRS unit connector A (39P) from the
SRS unit (see step 8 on page 24-34).
17. Disconnect the SRS inflator simulator from the SRS
070AZ-SNAA100
simulator lead. Do not disconnect the simulator
lead from the dashboard wire harness 4P connector.
18. Measure the resistance between the terminals of
both SRS simulator leads. There should be 1
less.
DASHBOARD WIRE HARNESS
4P CONNECTOR
Is the resistance as specif ied?
−
YES
unit connector A (39P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-223).
−
NO
the dashboard wire harness.
070AZ-SNAA100
Faulty SRS unit or poor connection at SRS
Open in the dashboard wire harness; replace
or
＊５３