Honda Accord 2008 Manual page 2730

07/11/02 09:42:59 61TA0000_240_0007
8. Install the belt in the reverse order of removal, and
note these items:
• Apply medium strength liquid thread lock to the
anchor bolts before reinstallation.
• Tighten the bolts by hand first, then tighten to the
specified torque.
• Check that the retractor locking mechanism
functions (see page 24-17).
• Assemble the washers, collars, and bushings on
the upper and lower anchor bolts as shown.
• Before installing the anchor bolts, make sure
there are no twists or kinks in the seat belt.
• Make sure the seat belt tensioner connector is
plugged in properly.
• Passenger's seat belt: Before attaching the front
seat belt lower anchor, make sure there are no
twists or kinks in the belts.
• Passenger's seat belt: Triangle marks (A) on the
anchor plate (B) and on the lower anchor (C)
must face the same side.
• Passenger's seat belt: Insert the hook on the
anchor plate into the lower anchor, and be sure
that the lower anchor is locked securely.
• Do the battery terminal reconnection procedure
(see page 22-89).
• Check for any DTCs that may have been set
during repairs, and clear them.
Upper anchor bolt installation
＊０６
UPPER ANCHOR
BOLT
THREAD LOCK
UPPER ANCHOR
COLLAR
BUSHING
TOOTHED
LOCK WASHER
Lower anchor bolt installation
WAVE WASHER
BUSHING
LOWER ANCHOR
BOLT
LOWER ANCHOR
Front seat belt lower anchor installation
A
C
SPRING WASHER
COLLAR COLLAR
WASHER
TOOTHED
LOCK WASHER
B
A
24-7
＊０７
＊０８