Honda Accord 2008 Manual page 2762

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:43:55 61TA0000_240_0039

ODS Unit Initialization

When a seat-back cover, seat-back cushion, and/or ODS

unit is replaced, initialize the ODS by doing this

NOTE: A new (uninitialized) ODS unit installed with a

faulty OPDS sensor can cause DTC 85-71.

1. Clear the DTC memory (see page 24-36).

2. Make sure the front passenger's seat is dry. Set the

seat-back in a normal position, and make sure there

is nothing on the seat.

3. Make sure the ignition switch is in LOCK (0).

4. Connect the HDS to the data link connector (DLC)

5. Turn the ignition switch to ON (II).

6. Make sure the HDS communicates with the vehicle

and the SRS unit. If it does not communicate,

troubleshoot the DLC circuit (see page 11-208).

7. From the HDS Main Menu, select SRS, then SRS,

then Calibration. In the Calibration Menu, select

ODS UNIT INITIALIZATION. Follow the screen

prompts to initialize the ODS unit.

8. Turn the ignition switch to LOCK (0).

9. Disconnect the HDS from the DLC.

NOTE: If the ODS unit fails to initialize after several

attempts, replace the OPDS sensor/seat-back and

retry. If the ODS unit continues to fail to initialize,

replace the ODS unit (see page 24-232).

ＴＡ０８Ａ００Ｈ４６４０００４３０８１ＢＢＡＴ００

Chapters

Table of Contents