Honda Accord 2008 Manual page 2837

07/11/02 09:48:20 61TA0000_240_0114
SRS
DTC Troubleshooting (cont'd)
4. Remove the left side C-pillar trim, for 2-door
(see page 20-110), for 4-door (see page 20-115),
then disconnect the SRS floor wire harness 2P
connector (A) from the left side curtain airbag
connector (B).
＊５１
070AZ-SNAA300
5. Connect the SRS inflator simulator (2
connectors) and simulator lead L to the SRS floor
wire harness.
6. Do the battery terminal reconnection procedure
(see page 22-89).
7. Clear the DTC memory.
8. Read the DTC (see page 24-36).
Is DT C 33-3x indicated?
YES
−
NO
airbag inflator; replace the left side curtain airbag
(see page 24-210).
9. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
24-114
B
07SAZ-TB4011A
A
− Go to step 9.
Short to another wire in the left side curtain
10. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the SRS inflator simulator from the SRS
simulator lead. Do not disconnect the simulator
lead from the SRS floor wire harness 2P connector.
12. Connect the SRS short canceller (070AZ-SAA0100)
to the No. 10 and the No. 11 terminals of SRS unit
connector B (39P) (see page 24-29).
13. Measure the resistance between the terminals of
the black SRS simulator lead (A). There should be
an open circuit or at least 1 M .
SRS FLOOR WIRE HARNESS
2P CONNECTOR
070AZ-SNAA300
A
Is the resistance as specif ied?
−
YES Faulty SRS unit or poor connection at SRS
unit connector B (39P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-223).
NO − Short to another wire in the SRS floor wire
harness; replace the SRS floor wire harness.
＊５２