Honda Accord 2008 Manual page 2880

07/11/02 09:50:51 61TA0000_240_0157
8. Disconnect gauge control module connector A
(32P) from the gauge control module (see page
22-332).
9. Install a jumper wire between the No. 16 and the
No. 17 terminals of SRS unit connector A (39P).
＊５１
10. Measure the resistance between the No. 29 and the
No. 30 terminals of gauge control module
connector A (32P). There should be 0 1.0
＊５２
GAUGE CONTROL MODULE CONNECTOR A (32P)
Is the resistance as specif ied?
YES
unit connector A (39P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-223).
NO −
connector A (39P) and the No. 29 terminal of gauge
control module connector A (32P), or between the
No. 17 terminal of SRS unit connector A (39P) and
the No. 30 terminal of gauge control module
connector A (32P); replace the faulty harness.
SRS UNIT CONNECTOR B (39P)
JUMPER WIRE
Wire side of female terminals
Wire side of female terminals
− Faulty SRS unit or poor connection at SRS
Open between the No. 16 terminal of SRS unit
− .
24-157