Honda Accord 2008 Manual page 2833

07/11/02 09:48:19 61TA0000_240_0110
SRS
DTC Troubleshooting (cont'd)
4. Disconnect the SRS floor wire harness 2P
connector (A) from the front passenger's side
airbag (B).
＊５１
5. Connect the SRS inflator simulator (2
connectors) and simulator lead L to the SRS floor
wire harness.
6. Do the battery terminal reconnection procedure
(see page 22-89).
7. Clear the DTC memory.
8. Read the DTC (see page 24-36).
Is DT C 32-9x indicated?
YES
NO −
airbag inflator; replace the front passenger's side
airbag (see page 24-209).
9. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
24-110
B
07SAZ-TB4011A
070AZ-SNAA300
− Go to step 9.
Short to ground in the front passenger's side
10. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the SRS inflator simulator from the SRS
simulator lead. Do not disconnect the simulator
lead from the SRS floor wire harness 2P connector.
12. Measure the resistance between each terminal of
the black SRS simulator lead (A) and body ground.
There should be an open circuit or at least 1 M .
SRS FLOOR WIRE HARNESS
2P CONNECTOR
A
070AZ-SNAA300
Is the resistance as specif ied?
YES − Faulty SRS unit or poor connection at SRS
unit connector B (39P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-223).
−
NO Short to ground in the SRS floor wire harness;
replace the SRS floor wire harness.
A
＊５２