Honda Accord 2008 Manual page 2839

Hide thumbs Also See for Accord 2008:
Table of Contents

Advertisement

07/11/02 09:48:21 61TA0000_240_0116
SRS
DTC Troubleshooting (cont'd)
10. Disconnect the SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the SRS inflator simulator from the SRS
simulator lead. Do not disconnect the simulator
lead from the SRS floor wire harness 2P connector.
12. Do the battery terminal reconnection procedure
(see page 22-89).
13. Turn the ignition switch to ON (II).
14. Measure the voltage between each terminal of the
black SRS simulator lead (A) and body ground.
There should be 0.5 V or less.
*52
SRS FLOOR WIRE HARNESS
2P CONNECTOR
Is the voltage as specif ied?
YES
unit connector B (39P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-223).
NO
replace the SRS floor wire harness.
24-116
24-116
070AZ-SNAA300
A
Faulty SRS unit or poor connection at SRS
Short to power in the SRS floor wire harness;
DTC 33-9x (''x'' can be 0 thru 9 or A thru F):
Short to Ground in the Left Side Curtain
Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead L 070AZ-SNAA300
NOTE:
• Before doing this troubleshooting procedure, review
SRS Precautions and Procedures (see page 24-23)
and General Troubleshooting Information (see page
24-35).
• 2-door: Before replacing the SRS unit, check the SRS
unit software version with the HDS. If the software
version is not the latest, update the SRS unit software
(see page 24-38) and retest.
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to ON (II), and check that
the SRS indicator comes on for about 6 seconds
and then goes off.
Does the SRS indicator stay on, and is DT C 33-9x
indicated?
YES
Go to step 3.
NO
Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
3. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
TA08A00K791000R339XFAAT00

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents