Honda Accord 2008 Manual page 2801

07/11/02 09:45:59 61TA0000_240_0078
SRS
DTC Troubleshooting (cont'd)
12. Check for continuity between the No. 5 and the
No. 9 terminals of SRS unit connector A (39P), and
between the No. 6 and the No. 10 terminals. There
should be no continuity.
＊５２
Is there continuity?
YES
NO −
(see page 24-223).
13. Disconnect the dashboard wire harness 4P
connector from the front passenger's airbag (see
step 3 on page 24-33).
14. Check for continuity between the No. 5 and the
No. 9 terminals of SRS unit connector A (39P), and
between the No. 6 and the No. 10 terminals. There
should be no continuity.
＊５３
Is there continuity?
YES
the dashboard wire harness.
NO −
front passenger's airbag (see page 24-207).
24-78 24-78
SRS UNIT CONNECTOR A (39P)
Wire side of female terminals
−
Go to step 13.
Faulty SRS unit; replace the SRS unit
SRS UNIT CONNECTOR A (39P)
Wire side of female terminals
−
Short in the dashboard wire harness; replace
Faulty front passenger's airbag; replace the
DTC 12-3x (''x'' can be 0 thru 9 or A thru F):
Short to Another Wire or Decreased
Resistance in the Front Passenger's Airbag
First Inflator
DTC 12-6x (''x'' can be 0 thru 9 or A thru F):
Short to Another Wire or Decreased
Resistance in the Front Passenger's Airbag
Second Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead J 070AZ-SNAA100
• SRS short canceller 070AZ-SAA0100
NOTE:
• Before doing this troubleshooting procedure, review
SRS Precautions and Procedures (see page 24-23)
and General Troubleshooting Information (see page
24-35).
• 2-door: Before replacing the SRS unit, check the SRS
unit software version with the HDS. If the software
version is not the latest, update the SRS unit software
(see page 24-38) and retest.
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to ON (II), and check that
the SRS indicator comes on for about 6 seconds
and then goes off.
Does the SRS indicator stay on, and is DT C 12-3x
or 12-6x indicated?
YES − Go to step 3.
NO − Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
3. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
ＴＡ０８Ａ００Ｋ７９１０００Ｒ１２３ＸＦＡＡＴ００