Honda Accord 2008 Manual page 2696

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 10:06:26 61TA0000_230_0252

Electrical Compass Zone Selection and Calibration

• You should do this procedure any time the electrical

compass unit is replaced.

• You should do this procedure in an open area away

from buildings, power lines, and other vehicles.

• If you see ''

indicator is shown in the display, the compass is self-

calibrating.

• The compass may need to be manually calibrated

after exposure to a strong magnetic field. If the

compass seems to be continually showing the wrong

direction and is not self-calibrating, do the following.

1. Check the No. 15 (10 A) fuse in the under-hood

fuse/relay box and the No. 5 (7.5 A) and No. 18

(7.5 A) fuses in the driver's under-dash fuse/relay

2. Turn the ignition switch to ON (II), then press and

hold the MENU button (A) until the beep (about 2

'' in the compass display and the CAL

3. Turn the selector knob (B) to select ZONE.

4. Press the selector knob (B) to enter your selection.

The display shows the currently selected zone

NOTE: If necessary, press the RETURN button (C) to

return to the previous display. Pressing the MENU

button (A) cancels the compass setting mode.

5. Find the zone for your area on the map. If the

correct zone is not shown, turn the selector knob

(B) to cycle the zone lists up or down.

6. Once the correct zone is displayed, press the

selector knob. The display then returns to normal.

ＴＡ０８ＡＮ０Ｊ２６３２４２０００００ＢＢＡＴ００

Chapters

Table of Contents