Honda Accord 2008 Manual page 2805

07/11/02 09:47:05 61TA0000_240_0082
SRS
DTC Troubleshooting (cont'd)
4. Disconnect the front passenger's airbag 4P
connector (A) from the dashboard wire harness.
＊５１
070AZ-SNAA100
5. Connect the SRS inflator simulator (2
connectors) and simulator lead J to the dashboard
wire harness.
6. Do the battery terminal reconnection procedure
(see page 22-89).
7. Clear the DTC memory.
8. Read the DTC (see page 24-36).
Is DT C 12-9x or 12-Bx indicated?
YES
NO −
airbag first or second inflator; replace the front
passenger's airbag (see page 24-207).
9. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
24-82
07SAZ-TB4011A
−
Go to step 9.
Short to ground in the front passenger's
10. Disconnect SRS unit connector A (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the SRS inflator simulator from the SRS
simulator lead. Do not disconnect the simulator
lead from the dashboard wire harness 4P connector.
12. Measure the resistance between each terminal of
the SRS simulator lead and body ground. There
A
should be an open circuit or at least 1 M .
DASHBOARD WIRE HARNESS
4P CONNECTOR
070AZ-SNAA100
Is the resistance as specif ied?
YES − Faulty SRS unit or poor connection at SRS
unit connector A (39P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-223).
NO − Short to ground in the dashboard wire
harness; replace the dashboard wire harness.
＊５２