Honda Accord 2008 Manual page 2814

07/11/02 09:47:08 61TA0000_240_0091
10. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
11. Connect a SRS short canceller (070AZ-SAA0100) to
the No. 14 and the No. 15 terminals of SRS unit
connector B (39P) (see page 24-29).
12. Measure the resistance between the No. 14 and the
No. 15 terminals of SRS unit connector B (39P).
There should be 2.0 3.0
＊５２
Is the resistance as specif ied?
YES
unit connector B (39P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-223).
−
NO
the SRS floor wire harness.
−
.
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
−
Faulty SRS unit or poor connection at SRS
Open in the SRS floor wire harness; replace
DTC 22-11: Short to Another Wire in the Front
Passenger's Seat Belt Tensioner (4-door)
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures (see page
24-23) and General Troubleshooting Information
(see page 24-35).
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to ON (II), then wait for 10
seconds.
3. Read the DTC (see page 24-36).
Is DT C 22-11 indicated?
YES − Go to step 4.
NO − Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
4. Read the DTC (see page 24-36).
Is DT C 21-11, 31-11, 32-11, 33-11, or 34-11
indicated with DT C 22-11?
YES − Go to step 5.
NO − Short in the SRS floor wire harness; replace
the SRS floor wire harness.
ＴＡ０８ＡＢ４Ｋ７９１０００Ｒ２２１１ＦＡＡＴ００
(cont'd)
24-91 24-91