07/11/02 09:47:07 61TA0000_240_0086
SRS
DTC Troubleshooting (cont'd)
4. Disconnect the SRS floor wire harness 4P
connector (A) from the driver's seat belt tensioner.
*51
070AZ-SNAA200
5. Connect the SRS inflator simulator (2
connectors) and simulator lead K to the SRS floor
wire harness.
6. Do the battery terminal reconnection procedure
(see page 22-89).
7. Clear the DTC memory.
8. Read the DTC (see page 24-36).
Is DT C 21-3x indicated?
YES
NO
−
replace the driver's seat belt for 4-door (see page
24-8), for 2-door (see page 24-5).
9. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
24-86
A
07SAZ-TB4011A
−
Go to step 9.
Short in the driver's seat belt tensioner;
10. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the simulator lead from the SRS floor
wire harness.
12. Connect a SRS short canceller (070AZ-SAA0100) to
the No. 12 and the No. 13 terminals of SRS unit
connector B (39P) (see page 24-29).
13. Measure the resistance between the No. 12 and the
No. 13 terminals of SRS unit connector B (39P).
There should be an open circuit or at least 1 M .
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
Is the resistance as specif ied?
YES
−
Faulty SRS unit or poor connection at SRS
unit connector B (39P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-223).
NO
−
Short in the SRS floor wire harness; replace
the SRS floor wire harness.
*52