Honda Accord 2008 Manual page 2863

07/11/02 09:49:38 61TA0000_240_0140
SRS
DTC Troubleshooting (cont'd)
10. Measure the resistance between the No. 32
terminal of SRS unit connector B (39P) and body
ground, and between the No. 33 terminal and body
ground. There should be an open circuit or at least
1 M .
＊０２
Is the resistance as specif ied?
YES
NO −
replace the SRS floor wire harness.
11. Do the battery terminal reconnection procedure
(see page 22-89).
12. Turn the ignition switch to ON (II).
13. Measure the voltage between the No. 32 terminal
of SRS unit connector B (39P) and body ground,
and between the No. 33 terminal and body ground.
There should be less than 1.0 V.
＊０３
Is the voltage as specif ied?
YES
NO −
replace the SRS floor wire harness.
24-140
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
−
Go to step 11.
Short to ground in the SRS floor wire harness;
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
−
Go to step 14.
Short to power in the SRS floor wire harness;
14. Turn the ignition switch to LOCK (0).
15. Connect the SRS inflator simulator (jumper
connector) and the black lead (A) of simulator lead
L to the SRS floor wire harness 2P connector (B).
B
07SAZ-TB4011A
A
16. Measure the resistance between the No. 32 and the
No. 33 terminals of SRS unit connector B (39P).
There should be less than 1
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
Is the resistance as specif ied?
YES − Faulty left side impact sensor (second) or
SRS unit; replace the left side impact sensor
(second) (see page 24-227). If the problem is still
present, replace the SRS unit (see page 24-223).
−
NO Open in the SRS floor wire harness; replace
the SRS floor wire harness.
070AZ-SNAA300
.
＊０４
＊５１