Honda Accord 2008 Manual page 2902

07/11/02 09:53:10 61TA0000_240_0179
9. Measure the resistance between the No. 5 terminal
of the ODS unit harness 18P connector and body
ground. There should be an open circuit or at least
1 M .
＊０３
Is the resistance as specif ied?
YES
NO −
replace the ODS unit harness.
10. Measure the resistance between the No. 5 terminal
and No. 15 terminal of the ODS unit harness 18P
connector. There should be an open circuit or at
least 1 M .
＊０４
Is the resistance as specif ied?
YES
(see page 24-232).
−
NO
replace the ODS unit harness.
ODS UNIT HARNESS 18P CONNECTOR
Wire side of female terminals
−
Go to step 10.
Short to ground in the ODS unit harness;
ODS UNIT HARNESS 18P CONNECTOR
Wire side of female terminals
− Faulty ODS unit; replace the ODS unit
Short to ground in the ODS unit harness;
11. Turn the ignition switch to LOCK (0).
12. Swap the connections between the front outer side
front passenger's weight sensor and the rear outer
side sensor.
13. Read the DTC.
Is DT C 24-13 indicated?
YES − Go to step 14.
NO − Faulty front passenger's weight sensor (front
outer side); replace the front passenger's seat
frame including all front passenger's weight
sensors (see page 24-230).
14. Turn the ignition switch to LOCK (0).
15. Disconnect the front passenger's weight sensor
(front outer side) connector (A) and front
passenger's weight sensor (rear outer side)
connector (B).
B
A
＊０５
(cont'd)
24-179