Honda Accord 2008 Manual page 2759

07/11/02 09:43:54 61TA0000_240_0036
SRS
General Troubleshooting Information (cont'd)
Reading the DTC
1. Make sure the ignition switch is in LOCK (0).
2. Connect the HDS to the data link connector (DLC)
(A).
＊０１
3. Turn the ignition switch to ON (II).
4. Make sure the HDS communicates with the vehicle
and the SRS unit. If it does not communicate,
troubleshoot the DLC circuit (see page 11-208).
5. Use the HDS to check for SRS DTCs.
6. Read and record the DTC.
NOTE: Only read DTCs from the SRS menu, not
from ODS or SWS menus unless instructed to
check SWS DTCs. SWS (ODS unit) DTCs are sub
codes of SRS unit DTCs. Only troubleshoot the
corresponding SRS DTCs.
7. Turn the ignition switch to LOCK (0), then wait for
10 seconds.
8. Disconnect the HDS from the DLC.
9. Do the troubleshooting procedure for the DTC.
24-36
A
Clear the DTC Memory With the HDS
NOTE: Make sure the battery is fully charged before
you begin.
1. Make sure the ignition switch is in LOCK (0).
2. Connect the HDS to the data link connector (DLC)
(A).
A
3. Turn the ignition switch to ON (II).
4. Make sure the HDS communicates with the vehicle
and the SRS unit. If it does not communicate,
troubleshoot the DLC circuit (see page 11-208).
5. In the SRS MENU of the HDS, select SRS, then DTC
to clear DTC(s).
6. Turn the ignition switch to LOCK (0), and wait for
10 seconds.
7. Disconnect the HDS from the DLC.
＊０２