Honda Accord 2008 Manual page 2821

07/11/02 09:47:11 61TA0000_240_0098
SRS
DTC Troubleshooting (cont'd)
10. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the SRS inflator simulator from SRS
simulator lead. Do not disconnect the simulator
lead from the SRS floor wire harness 2P connector.
12. Measure the resistance between the terminals of
the black SRS simulator lead (A). There should be
1.0
＊５２
SRS FLOOR WIRE HARNESS
2P CONNECTOR
Is the resistance as specif ied?
YES
unit connector B (39P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-223).
−
NO
wire harness; replace the SRS floor wire harness.
24-98 24-98
or less.
070AZ-SNAA300
A
− Faulty SRS unit or poor connection at SRS
Open or increased resistance in the SRS floor
DTC 31-11: Short to Another Wire in the
Driver's Side Airbag Inflator (4-door)
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures (see page
24-23) and General Troubleshooting Information
(see page 24-35).
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to ON (II), then wait for 10
seconds.
3. Read the DTC (see page 24-36).
Is DT C 31-11 indicated?
YES − Go to step 4.
NO − Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
4. Read the DTC (see page 24-36).
Is DT C 21-11, 22-11, 32-11, 33-11, or 34-11
indicated with DT C 31-11?
YES − Go to step 5.
NO − Short in the SRS floor wire harness; replace
the SRS floor wire harness.
ＴＡ０８ＡＢ４Ｋ７９１０００Ｒ３１１１ＦＡＡＴ００