Honda Accord 2008 Manual page 2895

07/11/02 09:53:07 61TA0000_240_0172
SRS
DTC Troubleshooting (cont'd)
9. Measure the resistance between the No. 3 terminal
of the ODS unit harness 18P connector and body
ground. There should be an open circuit or at least
1 M .
＊０３
Is the resistance as specif ied?
YES
NO −
replace the ODS unit harness.
10. Measure the resistance between the No. 3 terminal
and the No. 13 terminal of the ODS unit harness
18P connector. There should be an open circuit or
at least 1 M .
＊０４
Is the resistance as specif ied?
YES
(see page 24-232).
−
NO
replace the ODS unit harness.
24-172
ODS UNIT HARNESS 18P CONNECTOR
Wire side of female terminals
−
Go to step 10.
Short to ground in the ODS unit harness;
ODS UNIT HARNESS 18P CONNECTOR
Wire side of female terminals
− Faulty ODS unit; replace the ODS unit
Short to ground in the ODS unit harness;
11. Turn the ignition switch OFF to LOCK (0).
12. Swap the connections between the front inner side
front passenger's weight sensor and the rear inner
side sensor.
13. Read the DTC.
Is DT C 14-13 indicated?
YES − Go to step 14.
NO − Faulty front passenger's weight sensor (front
inner side); replace the front passenger's seat
frame including all four front passenger's weight
sensors (see page 24-230).
14. Turn the ignition switch to LOCK (0).
15. Disconnect the front passenger's weight sensor
(front inner side) connector (A) and front
passenger's weight sensor (rear inner side)
connector (B).
＊５１
B
A