Honda Accord 2008 Manual page 2907

07/11/02 09:54:14 61TA0000_240_0184
SRS
DTC Troubleshooting (cont'd)
19. Turn the ignition switch to LOCK (0).
20. Disconnect the ODS unit harness 3P connector (A)
from the front passenger's weight sensor (rear
outer side).
＊０８
A
21. Read the DTC.
Is DT C 26-14 indicated?
YES
−
NO
outer side); replace the front passenger's seat
frame including all four front passenger's weight
sensors (see page 24-230).
22. Turn the ignition switch to LOCK (0).
23. Disconnect the ODS unit harness 18P connector (A)
from the ODS unit.
＊０９
24-184
− Go to step 22.
Faulty front passenger's weight sensor (rear
24. Measure the resistance between the No. 11
terminal of the ODS unit harness 18P connector
and body ground. There should be an open circuit
or at least 1 M .
ODS UNIT HARNESS 18P CONNECTOR
Is the resistance as specif ied?
−
YES Go to step 25.
NO − Short to ground in the ODS unit harness;
replace the ODS unit harness.
25. Measure the resistance between the No. 11
terminal and No. 16 terminal of front passenger's
seat wire harness 18P connector. There should be
an open circuit or at least 1 M .
ODS UNIT HARNESS 18P CONNECTOR
A
Is the resistance as specif ied?
YES − Faulty ODS unit; replace the ODS unit
(see page 24-232).
−
NO Short in the ODS unit harness; replace the
ODS unit harness.
Wire side of female terminals
Wire side of female terminals
＊１０
＊１１