Honda Accord 2008 Manual page 2684

07/11/02 10:05:52 61TA0000_230_0240
Forced Starting of Display
Special tools required
SCS Service Connector 07PAZ-0010100
1. Turn the ignition switch to LOCK (0).
2. Connect the SCS service connector (A) to the
navigation service connector (B) located behind the
navigation unit.
＊０１
3. Turn the ignition switch to ON (II).
4. Check that the diagnosis menu for the picture
diagnosis starts up, and then changes to the
system link menu.
NOTE: If the display fails to display the system link
screen, refer to no picture is displayed (see page
23-219).
ＴＡ０８ＡＮ１Ｊ３６１００００００００ＬＢＡＴ０１
B
A
07PAZ-0010100
DVD-ROM/CD-ROM Replacement
NOTE: Check any official Honda service website for
more service information about the navigation system.
1. Turn the ignition switch to ON (II).
2. Push the open button (A) of the navigation unit
located on the left side of the trunk.
3. Press the EJECT button (B).
4. Remove the DVD-ROM/CD-ROM.
5. Insert the new DVD-ROM/CD-ROM with the white
label facing up.
6. Close the front cover. Do not turn the ignition
switch to LOCK (0); watch the navigation screen
until the data is downloaded to the navigation unit.
7. Do the Map Matching (see page 23-129).
NOTE: After servicing, the front cover and PC card
slot door must be closed. If you start up the
navigation system with the front cover or PC card
slot door open, the display will indicate an error
message.
ＴＡ０８ＡＮ１Ｊ３６１０００４２５２５ＫＢＡＴ０２
B
A
23-239 23-239
＊０１