Honda Accord 2008 Manual page 2792

07/11/02 09:45:56 61TA0000_240_0069
10. Disconnect the dashboard wire harness 4P
connector (A) from the cable reel.
＊５２
07SAZ-TB4011A
11. Connect the SRS inflator simulator (2
connectors) and the simulator lead to the
dashboard wire harness.
12. Do the battery terminal reconnection procedure
(see page 22-89).
13. Clear the DTC memory.
14. Read the DTC.
Is DT C 11-3x or 11-6x indicated?
YES
NO −
(see page 24-220).
A
−
Go to step 15.
Short in the cable reel; replace the cable reel
15. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
16. Disconnect SRS unit connector A (39P) from the
SRS unit (see step 8 on page 24-34).
17. Disconnect the SRS inflator simulator from the SRS
070AZ-SNAA100
simulator lead. Do not disconnect the simulator
lead from the dashboard wire harness 4P connector.
18. Connect a SRS short canceller (070AZ-SAA0100) to
the No. 3 and the No. 4 terminals and the No. 7 and
the No. 8 terminals of SRS unit connector A (39P)
(see page 24-29).
19. Measure the resistance between the terminals of
both SRS simulator leads. There should be an open
circuit or at least 1 M .
DASHBOARD WIRE HARNESS
4P CONNECTOR
Is the resistance as specif ied?
YES −
unit connector A (39P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-223).
−
NO
the dashboard wire harness.
070AZ-SNAA100
Faulty SRS unit or poor connection at SRS
Short in the dashboard wire harness; replace
＊５３
24-69