Honda Accord 2008 Manual page 2885

07/11/02 09:53:03 61TA0000_240_0162
SRS
DTC Troubleshooting (cont'd)
DTC 62-2x (''x'' can be 0 thru 9 or A thru F):
Short in the Front Passenger's Seat Belt
Buckle Switch
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures (see page
24-23) and General Troubleshooting Information
(see page 24-35).
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to LOCK (0), then wait for
10 seconds.
3. Turn the ignition switch to ON (II), then buckle and
unbuckle the driver's seat belt several times.
4. Read the DTC (see page 24-36).
Is DT C 62-2x indicated?
−
YES Go to step 5.
NO − Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
5. Turn the ignition switch to LOCK (0).
24-162
6. Disconnect the SRS floor wire harness 2P
connector (A) from the front passenger's seat belt
buckle switch.
7. Turn the ignition switch to ON (II).
8. Read the DTC (see page 24-36).
Is DT C 62-2x indicated?
YES − Short to ground in the SRS floor wire
harness; replace the SRS floor wire harness.
−
NO Faulty front passenger's seat belt buckle
switch; replace the front passenger's seat belt
buckle assembly (see page 24-10).
ＴＡ０８Ａ００Ｋ７９１０００Ｒ６２２ＸＦＡＡＴ００
＊０１
A