Honda Accord 2008 Manual page 2819

07/11/02 09:47:10 61TA0000_240_0096
SRS
DTC Troubleshooting (cont'd)
4. Disconnect the SRS floor wire harness 4P
connector (A) from the front passenger's seat belt
tensioner.
＊５１
070AZ-SNAA200
5. Connect the SRS inflator simulator (2
connectors) and simulator lead K to the SRS floor
wire harness.
6. Do the battery terminal reconnection procedure
(see page 22-89).
7. Clear the DTC memory.
8. Read the DTC (see page 24-36).
Is DT C 22-9x indicated?
YES
NO −
belt tensioner; replace the front passenger's seat
belt for 4-door (see page 24-8), for 2-door (see page
24-5).
9. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
24-96
A
07SAZ-TB4011A
− Go to step 9.
Short to ground in the front passenger's seat
10. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the simulator lead from the SRS floor
wire harness.
12. Measure the resistance between the No. 14
terminal of SRS unit connector B (39P) and body
ground, and between the No. 15 terminal and body
ground. There should be an open circuit or at least
1 M .
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
Is the resistance as specif ied?
YES − Faulty SRS unit or poor connection at SRS
unit connector B (39P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-223).
−
NO Short to ground in the SRS floor wire harness;
replace the SRS floor wire harness.
＊５２